Replacement lamp for SIG Blomax 4

Sun, 19 Jul 2026 00:24:58 +0800

Getting the Heat Right for Your Sidel Matrix

When you’re blowing PET, hitting that perfect temperature curve isn’t about getting lucky. It’s pure physics. Here’s the problem: when you swap out the original lamps in a Sidel Matrix, even a tiny tweak in wattage or light output messes with your heating profile. Suddenly, you’re dealing with uneven preforms and wall thickness that just isn’t right. It’s a headache you don’t need. That’s why we build our replacement lamps to match the original specs exactly. No guessing. The Electrical Side of Things We make sure the voltage and wattage are a dead ringer for the Sidel gear. Think about it this way—if your machine is set for a high-voltage load and you drop in a lamp with a slightly different resistance, your heat flux shifts. Not good. We keep the electrical footprint identical so you don’t have to mess around with recalibrating your power controllers. You just pop them in, and your ramp-up time stays exactly where it should be. It’s All in the Glass The real secret to keeping that temperature curve steady is the quartz and the halogen fill. We use high-purity quartz because it can take the punch of rapid heating and cooling without cracking. But the light is where it really matters. We tune the spectral output to hit the specific absorption bands of PET. If the wavelength is off, the heat just sits on the surface of the plastic. It doesn’t soak in. We calibrate our emission so the heat penetrates the core of the preform at the same speed as the factory lamps. Real-World Setup These are true drop-in replacements. We use the same connector footprints so they fit tight. And a quick tip from experience: a loose connection at the terminal is the fastest way to fry a lamp. Also, remember that running these at full blast creates a lot of ambient heat. Keep your oven vents clear of dust and debris so your sockets don’t overheat. We handle the gritty technical specs so you can just keep your lines running fast.

4 on IR Lamp News

Replacement lamp for SIG Blomax 4

Getting the Heat Right for Your Sidel Matrix