infrared heater for pet blowing heating lamps 222mm 1200w halogen heating lamp

infrared heater for pet blowing heating lamps 222mm 1200w halogen heating lamp

Infrared Halogen Heating Lamp for PET Blowing: 1200W, 222mm, R7s Fit

We built this infrared halogen heating lamp for one reason: to nail the heating step in PET blowing. No fluff. Just the right size and power for the job. It’s 222mm long and runs at 1200W, which lines up perfectly with the space and heat needs of most blow molding setups.

Power, Voltage, and Size: What It Means on the Floor

The 1200W rating isn’t just a number—it gives you heat you can count on. You can fine-tune the temperature by adjusting the lamp distance and your line speed. The 222mm length focuses the heat right where the preform needs it, so you’re not wasting energy all over the place. And it wakes up fast. Turn it on, and it responds quickly. Flip it off, and it stops pushing heat just as fast. That kind of punch comes with a heads-up: the heat is dense. Make sure your reflector is doing its job and that airflow around the lamp is solid. Otherwise, the lamp and nearby parts can run hotter than you want.

What It’s Made Of: Halogen, Quartz, and an R7s Base

Inside, halogen chemistry keeps the filament steady even at high temps, so the output stays consistent over the lamp’s life. The quartz envelope handles the shock of repeated start-stop cycles and holds up under intense heat. No drama. It just keeps going. And the R7s base? It’s the practical choice. It locks in fast, handles the electrical load safely, and makes replacement a simple drop-in when you’re already on the line.

Why This Lamp Shines in PET Blowing

On the shop floor, PET blowing needs heat that’s uniform and fast. This lamp delivers—infrared energy hits the preform surface without cooking the core. That helps you keep wall thickness consistent and cycle times stable. It’s also compact, so it fits into tight heating stations without fighting for space. And because it’s wired for the R7s connection, installation is straightforward. No overcomplicated steps. Just remember the basics: keep the cooling in place and keep the reflector aligned. That way, the heat lands exactly where it should—on the preform.