Getting the Heat Where It Actually Matters for Your Horse
Most of the heaters you’ll find for horses are just generic lamps. They blast a lot of heat, but it mostly sits on the surface. We spent a lot of time in the lab rethinking how this actually works because, for muscle recovery, surface heat isn’t enough. You need that warmth to sink deep into the tissue. Here’s the thing about the physics. Most standard lamps waste a ton of energy creating visible light. Not only is that a waste, but it can actually stress a horse out. We tweaked the filaments and the gas inside the tubes to shift that energy. Instead of a bright light, we focused the power into infrared bands that cut through the skin and hit the muscles. It means your horse gets the deep therapy they need without the risk of scorching their skin. Built for the stable, not a lab Stables are messy. They’re dusty, damp, and generally tough on gear. That’s why we use high-purity quartz glass. We made sure the coating won’t flake off just because the lamp heats up and cools down a dozen times a day. And since we know you probably already have fixtures installed, we made these easy. Whether you’re using R7s or SK15 connectors, these just slide right in. We also used a higher voltage setup, which lets us keep the lamps small without losing any of that heat density. A few things to keep in mind Now, because these are so powerful, you have to be smart about where you put them. If you mount them too close, you’re asking for surface burns. It’s really important to get your mounting brackets just right so there’s a consistent gap between the lamp and the animal. One last tip: check your power. Filaments hate voltage spikes—they’ll burn out way faster than they should. If your power grid is a bit flaky, grab a dedicated regulator. It’ll keep the heat steady and make your lamps last a lot longer.